Copiadora / pantógrafo de Aluminio / PVC C-500-AH

  • Fuera de stock
7.521,36 €
Impuestos incluidos

Fresadora copiadora (Pantógrafo) de un solo cabezal para el fresado en aluminio y perfil de hierro de espesor 1,5 mm.

Guía de Tallas
Guía de Tallas
CLOTHES
MEASUREXS/34S/36M/38-40L/40-42
UK681012
USA46810
FRA36384042
Waist (cm)64687276
Chest (cm)81858993
Seat (cm)899397101
Inseam (cm)81828384


SHOES
FOOT IN INCHESFOOT IN CMUSAEuroUK
23.56395
24.16.539.55.5
24.87.5406
1025.48417
10¼25.78.541.57.5
10½269428
10¾27.39.542.59.5

How to Take Clothing Measurements

  1. Get a flexible measuring tape. These are often sold in craft stores
  2. Neck:
    • Measure around the base of the neck in inches.
    • Round up to the nearest half inch.
  3. Chest:
    • Wrap tape measure under armpits around fullest part of chest (usually right above nipples
  4. Sleeve:
    • Bend your elbow and rest your hand on your hip.
    • Have someone measure from the middle of the back of your neck to your wrist by putting the tape measure over your shoulder, around your elbow and to your wrist.
  5. Waist:
    • Wrap tape measure around where you normally wear your pants. Keep tape measure a little loose by keeping a finger between the tape measure and your waist.
  6. Inseam:
    • Put on a pair of shoes.Have someone measure from your crotch to back of the heel, where you want your pants to end.
  7. Hands:
    • Measure around the hand at the fullest part (exclude thumb). The number of inches shows the size of the glove.
Cantidad
  Fuera de stock

  Política de seguridad

Trabajamos con varias opciones de pago para ofrecerte la mas ventajosa en cada momento.

  Política de entrega

El plazo de entrega puede variar en relación con el stock y tiempo de producción o importación.

  Política de devolución

Lee nuestra política de devolución para cualquier duda.

- Máquina semiautomática para realizar alojamientos de cerraduras, bisagras, bombines, etc. en carpintería de aluminio o PVC.

- Con variador electrónico para el fresado de hierro.

- El fresado se realiza mediante plantilla (con dos copiadores) o con topes transversales, longitudinales y verticales.

- La refrigeración es automática por pulverización.

- El cabezal dispone de dispositivo de paro a la altura que se desee para realizar el fresado.

- Dimensiones mesa 500 x 280 mm.

- Recorrido longitudinal 260 mm.

- Recorrido transversal 140 mm.

- Desplazamiento vertical 150 mm.

- Motor 1.00 Hp.

- Velocidad de corte 2000-7000 rpm.

- Diámetro mango fresa 10 (opcional otros diámetros) mm.

OPCIONES:

- Armario / base Giratoria.

Detalles del producto